All about Ford Mondeo

Crankshaft speed/position sensor - checking, removal and refitting
Engine electrical systems / Crankshaft speed/position sensor - checking, removal and refitting


Checking
1 See Section 4 of Chapter 6.

Removal and refitting
2 Disconnect the battery negative (earth) lead - see Section 1.

3 Raise the front of the vehicle, and support it securely on axle stands.

Warning: Do not place any part of your body under a vehicle when itТs supported only by a jack!

4 Unplug the sensorТs electrical connector (see illustration).

9.4 Location of crankshaft speed/position sensor - connector arrowed - in
9.4 Location of crankshaft speed/position sensor - connector arrowed - in front of cylinder block/crankcase

5 Undo the sensorТs retaining screw and withdraw the sensor. The sensorТs bracket cannot be unbolted from the cylinder block/crankcase unless the transmission and flywheel/driveplate have been removed (see Chapter 2).

6 Refitting is the reverse of the removal procedure.


© 2018 www.fordmon.ru. All Rights Reserved.