All about Ford Mondeo

Starter motor - removal and refitting
Engine electrical systems / Starter motor - removal and refitting


1 Disconnect the battery negative (earth) lead - see Section 1.

2 Remove the air mass meter and resonator - refer to Chapter 4.

3 Unscrew the upper two starter motor mounting bolts, noting that one also secures an engine/transmission earth lead (see illustration).

16.3 Unscrew upper two starter motor mounting bolts (arrowed) from above
16.3 Unscrew upper two starter motor mounting bolts (arrowed) from above

4 Raise the front of the vehicle, and support it securely on axle stands.

Warning: Do not place any part of your body under a vehicle when it’s supported only by a jack!

5 Unscrew the nuts to disconnect the wiring from the starter/solenoid terminals.

6 Remove the remaining starter motor mounting bolt (see illustration). Remove the starter.

16.6 Disconnect starter motor wiring (A), then unscrew remaining mounting
16.6 Disconnect starter motor wiring (A), then unscrew remaining mounting bolt (B), and remove starter motor from beneath vehicle

7 Refitting is the reverse of the removal procedure. Tighten the bolts to the specified torque wrench settings.


© 2018 www.fordmon.ru. All Rights Reserved.