
All about Ford Mondeo
Bumpers - removal and refittingBodywork and fittings / Bumpers - removal and refitting
Removal
Front bumper
1 Apply the handbrake, jack up the front of
the vehicle and support it on axle stands.
2 Where applicable, remove the foglights from the front bumper (Chapter 12).
3 Where applicable, disconnect the tubing from the headlight washer jets.
4 Unscrew the screws securing the wheel arch liners to the front bumper (see illustration).
6.4 Screw (arrowed) securing the wheel arch liner to the front bumper
5 Unscrew the bumper mounting nuts, and withdraw the bumper forwards from the vehicle, at the same time disconnecting the guides from the side pins (see illustrations).
6.5A Front bumper mounting bolt (arrowed)
6.5B Disconnecting the front bumper from the side guides
Rear bumper
6 Chock the front wheels, jack up the rear of
the vehicle and support it on axle stands.
7 Disconnect the rear exhaust mounting rubber, and support the exhaust system on an axle stand.
8 Remove the screws securing the wheel arch liners to the rear bumper.
9 Unscrew the bumper mounting nuts, and withdraw the bumper rearwards from the vehicle, at the same time disconnecting the guides from the side pins (see illustration).
6.9 Rear bumper mounting nuts
Refitting
Front and rear bumpers
10 Refitting is a reversal of the removal
procedure. Make sure that the guides locate
correctly on the side pins.







