All about Ford Mondeo

Seats - removal and refitting
Bodywork and fittings / Seats - removal and refitting


Removal
Front seat
1 Release the seat belt, and slide the seat fully forwards.

2 Using a Torx key, undo the screws and remove the rear mounting trims, then unscrew the rear mounting bolts (see illustrations).

27.2A Unscrew the Torx-headed screws . . .
27.2A Unscrew the Torx-headed screws . . .

27.2B . . . and remove the mounting trims for access to the front seat rear
27.2B . . . and remove the mounting trims for access to the front seat rear mounting bolts

3 Slide the seat fully rearwards.

4 Where electric seats are fitted, disconnect the battery negative (earth) lead (Chapter 5, Section 1). Disconnect the seat wiring multiplugs (see illustration).

27.4 Disconnecting an electric seat multiplug
27.4 Disconnecting an electric seat multiplug

5 Unscrew the front mounting bolts, and remove the seat from the vehicle (see illustration).

27.5 Front seat front mounting bolt
27.5 Front seat front mounting bolt

Rear seat cushion
6 Fold the rear seat cushion forwards. (Note that, on some models, the seat cushion is held in place by screws which must be removed first.) Using a Torx key, unscrew and remove the mounting bolts from the hinges on each side (see illustration).

27.6 Rear seat cushion hinge bolt
27.6 Rear seat cushion hinge bolt

7 Withdraw the seat cushion from the vehicle.

Rear seat backrest
8 Fold the rear seat cushion and both backrests forwards.

9 Unclip the backrest rear trims, where fitted, and raise them.

10 Using a Torx key, unscrew the mounting bolts (see illustration).

27.10 Rear seat backrest mounting bolts
27.10 Rear seat backrest mounting bolts

11 Withdraw the backrest from inside the vehicle.

Rear seat side bolster
12 Fold the rear seat backrest forwards.

13 On low-series models, remove the screw and pull the bolster forwards to disengage the clips. On high-series models, simply pull the bolster upwards to disengage the clips.

Refitting
14 Refitting is a reversal of the removal procedure, but tighten the mounting bolts to the specified torque.


© 2018 www.fordmon.ru. All Rights Reserved.