All about Ford Mondeo

Tailgate wiper motor assembly - removal and refitting
Body electrical system / Tailgate wiper motor assembly - removal and refitting


Removal
1 Disconnect the battery negative (earth) lead (refer to Chapter 5, Section 1).

2 Remove the tailgate wiper arm as described in Section 15.

3 Remove the tailgate inner trim panel by unscrewing the retaining screws.

4 Release the multi-plug from the clip, then disconnect it (see illustration).

17.4 Disconnecting the tailgate wiper motor multi-plug
17.4 Disconnecting the tailgate wiper motor multi-plug

5 Disconnect the wiper motor earth lead.

6 Unscrew the mounting bolts, and remove the wiper motor from inside the tailgate (see illustrations).

17.6A Unscrew the mounting bolts . . .
17.6A Unscrew the mounting bolts . . .

17.6B . . . and remove the tailgate wiper motor assembly (Hatchback shown -
17.6B . . . and remove the tailgate wiper motor assembly (Hatchback shown - Estate similar)

7 Unbolt and remove the mounting plate. If necessary, remove the mounting rubbers for renewal (see illustrations).

17.7A Tailgate wiper motor assembly and mounting plate
17.7A Tailgate wiper motor assembly and mounting plate

17.7B A mounting rubber removed from the mounting plate
17.7B A mounting rubber removed from the mounting plate

Refitting
8 Refitting is a reversal of the removal procedure. Make sure that the wiper motor is in its УparkedФ position before fitting the wiper arm.


© 2018 www.fordmon.ru. All Rights Reserved.