All about Ford Mondeo

Heater/air conditioning controls - removal and refitting
Cooling, heating, and air conditioning systems / Heater/air conditioning controls - removal and refitting


Blower/air conditioning control Removal
1 Disconnect the battery negative (earth) lead (see Chapter 5, Section 1).

2 Remove the ashtray. Referring to the relevant Sections of Chapter 11, undo the two upper screws from the centre console and pull out the cassette storage compartment, then remove the radio/cassette player.

3 Pull the heater control/radio bezel out of the three clips securing its top edge, pull it forwards and unplug the switch electrical connector (where fitted).

4 Pull off the heater control knobs, and remove the screw securing each end of the heater control unit (see illustration). Pull the control unit out of the facia.

10.4 Remove screws (arrowed) securing each end of heater control unit
10.4 Remove screws (arrowed) securing each end of heater control unit

5 Unplug the two electrical connectors from the blower/air conditioning control. Remove the retaining screw and withdraw the control, twisting it to release it from the panel.

Refitting
6 Refitting is the reverse of the removal procedure. Check the operation of the control on completion.

Temperature control
Removal
7 Remove the heater control unit as described in paragraphs 1 to 4 above.

8 On vehicles without air conditioning, unhook the operating cable from the temperature control (see illustration); where air conditioning is fitted, unplug the control’s electrical connector. Undo the retaining screw, and withdraw the control.

10.8 Unhooking operating cable from temperature control - note retaining
10.8 Unhooking operating cable from temperature control - note retaining screw (arrowed)

Refitting
9 Refitting is the reverse of the removal procedure; check the operation of the control on completion.

Air distribution control Removal
10 Remove the heater control unit as described in paragraphs 1 to 4 above. Unplug the electrical connectors, and unhook the operating cable (where fitted) to withdraw the unit (see illustration).

10.10 Unplugging electrical connectors from rear of heater control unit
10.10 Unplugging electrical connectors from rear of heater control unit

11 Use a pair of slim screwdrivers to release the clips on each side of the control, then withdraw the control from the unit.

Refitting
12 Refitting is the reverse of the removal procedure. Check the operation of the controls on completion.


© 2018 www.fordmon.ru. All Rights Reserved.